ELECTRONIC SHIFT LEVER SYSTEM > DTC CHECK / CLEAR |
| CHECK FOR DTCS (Using the Techstream) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Chassis / Transmission Control / Trouble Codes.
Check for DTCs and freeze frame data, and then write them down.
Check the details of the DTCs.
| CHECK FOR DTCS (Systems other than the transmission control ECU) |
If DTCs are present, check the relevant systems.
| CLEAR DTCS (Using the Techstream) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Chassis / Transmission Control / Trouble Codes.
Clear the DTCs and freeze frame data.
| CLEAR DTCS (Without using the Techstream) |
Turn the power switch off.
Remove the P CON MAIN fuse from the engine room junction block assembly located inside the engine compartment for more than 60 seconds.
Check for DTCs again to see if the DTCs are cleared.