Home › Drivetrain › P410 HYBRID TRANSMISSION / TRANSAXLE › ELECTRONIC SHIFT LEVER SYSTEM

DTC    C2307    Power Supply

for Preparation Click here


DESCRIPTION

The shift control actuator consists of the parking lock motor and the rotation angle sensor. The transmission control ECU receives a P position switch signal from the power management control ECU (HV CPU) and activates the parking lock motor by controlling current, causing the parking lock mechanism to switch. The transmission control ECU stores this DTC when it detects a malfunction in the parking lock motor system and/or the ground circuit.

DTC No.
DTC Detection Condition
Trouble Area
C2307
With the power switch on (IG) (IG circuit malfunction is not detected), current of the parking lock motor is 50 A or more or there is an open in the transmission control ECU terminal E1 circuit for 0.1 seconds or more.
  1. Transmission control ECU assembly
  2. Wire harness or connector

WIRING DIAGRAM


C225846E03


INSPECTION PROCEDURE

NOTICE:
It is not possible to clear the following DTCs using the Techstream: DTCs C2300 (Actuator System Malfunction), C2301 (Shift Changing Time Malfunction), C2303 (Short in Power Source Relay Circuit), C2304 (Open or Short Circuit in U Phase), C2305 (Open or Short Circuit in V Phase), C2306 (Open or Short Circuit in W Phase), C2307 (Power Supply) and C2309 (Open in B+ Circuit). After the repair, it is necessary to disconnect the P CON MAIN fuse and wait for at least 60 seconds to clear the DTCs.

1.CHECK HARNESS AND CONNECTOR (TRANSMISSION CONTROL ECU ASSEMBLY - BODY GROUND)
  1. Disconnect connector A24 from the transmission control ECU assembly.



    C208987E10
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance (Check for Open):
    Tester Connection
    Switch Condition
    Specified Condition
    A24-1 (E1) - Body ground
    Power switch off
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Transmission Control ECU Assembly)

  1. Connect the transmission control ECU assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (TRANSMISSION CONTROL ECU ASSEMBLY - SHIFT CONTROL ACTUATOR)
  1. Disconnect connector A23 from the transmission control ECU assembly.

  1. Disconnect connector D2 from the shift control actuator assembly.



    C210299E12
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance (Check for Short):
    Tester Connection
    Switch Condition
    Specified Condition
    A23-5 (MUA) or D2-1 (MUA) - Body ground and other terminals
    Power switch off
    10 kΩ or higher
    A23-2 (MVA) or D2-6 (MVA) - Body ground and other terminals
    Power switch off
    10 kΩ or higher
    A23-1 (MWA) or D2-7 (MWA) - Body ground and other terminals
    Power switch off
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Transmission Control ECU Assembly)
    *b
    Front view of wire harness connector
    (to Shift Control Actuator Assembly)

  1. Connect the shift control actuator assembly connector.

  1. Connect the transmission control ECU assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TRANSMISSION CONTROL ECU ASSEMBLY (Click here)