Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH

STOP LIGHT SWITCH > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT STOP LIGHT SWITCH ASSEMBLY


    E233265E20
  1. Disconnect the A67 connector from the stop light switch assembly.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A67-1 (B) - A67-3 (GND)
    Power switch off
    11 to 14 V
    A67-5 (B) - A67-3 (GND)
    Power switch on (IG)
    11 to 14 V

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A67-3 (GND) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Stop Light Switch Assembly)
    If the result is not as specified, repair or replace the wire harness or connector.



    E233266E18
  1. Reconnect the A67 connector to the stop light switch assembly.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A67-2 (L) - A67-3 (GND)
    Power switch off, brake pedal not depressed
    Below 1 V
    A67-2 (L) - A67-3 (GND)
    Power switch off, brake pedal depressed
    11 to 14 V
    A67-4 (L) - A67-3 (GND)
    Power switch on (IG), brake pedal not depressed
    11 to 14 V
    A67-4 (L) - A67-3 (GND)
    Power switch on (IG), brake pedal depressed
    Below 1 V

    Text in Illustration 
    *1
    Component with harness connected
    (Stop Light Switch Assembly)
    If the result is not as specified, replace the stop light switch assembly.