Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM

WIPER AND WASHER SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK HEADLIGHT CLEANER CONTROL RELAY
  1. Disconnect the A44 headlight cleaner control relay connector.



  2. Measure the voltage and resistance according to the value(s) in the table below.


    E119074E05


    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    A44-1 (HDLO) - A44-4 (E)
    L - W-B
    Low beam headlight signal
    Light control switch in head position
    Below 1 V
    Light control switch off
    11 to 14 V
    A44-2 (H) - A44-4 (E)
    LG - W-B
    Headlight cleaner switch operation signal
    Headlight cleaner switch off
    11 to 14 V
    Headlight cleaner switch on
    Below 1 V
    A44-3 (IG) - A44-4 (E)
    B - W-B
    Power switch on (IG) signal (Power source circuit)
    Power switch off
    Below 1 V
    Power switch on (IG)
    11 to 14 V
    A44-4 (E) - Body ground
    W-B - Body ground
    Body ground
    Always
    Below 1 Ω
    A44-5 (FRWA) - A44-4 (E)
    R - W-B
    Front washer switch signal
    Front washer switch off
    11 to 14 V
    Front washer switch on
    Below 1 V
    If the result is not as specified, there may be a malfunction in the wire harness.