Home › Engine / Hybrid System › 2ZR-FXE EMISSION CONTROL › CANISTER

CANISTER > REMOVAL

for Preparation Click here



1. REMOVE REAR NO. 2 FLOOR BOARD (for Separate Type)


    B227787E01
  1. Disengage the 2 guides <A> as shown in the illustration.

  1. Disengage the 3 guides <B> and remove the rear No. 2 floor board.



2. REMOVE REAR DECK FLOOR BOX
  1. Remove the rear deck floor box.



3. REMOVE REAR NO. 3 FLOOR BOARD


    B227791
  1. Disengage the 2 guides and remove the rear No. 3 floor board.



4. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL


5. REMOVE REAR FLOOR STEP UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)


    A212659E01
  1. Remove the 5 clips (A) and nut.

  1. Disconnect the 3 clips (B) and remove the rear floor step under cover sub-assembly.



6. REMOVE CHARCOAL CANISTER ASSEMBLY


    A215701E01
  1. Using a screwdriver, pry up the retainer.

    HINT:
    Do not remove the retainer.

  1. Disconnect the tube clamp, purge line hose and vent line tube.

    NOTICE:

    1. A098068E06
      Remove any dirt or foreign matter on the vent line tube connector before performing this work.
      Text in Illustration 
      *1
      Vent Line Tube Connector
      *2
      O-ring
      *3
      Retainer
    2. Do not allow any scratches or foreign matter on the parts when disconnecting them as the vent line tube connector has an O-ring that seals the pipe.
    3. Perform this work by hand. Do not use any tools.
    4. Do not forcibly bend, twist or turn the nylon tube.
    5. Protect the disconnected part by covering it with a plastic bag after disconnecting the vent line tube.
    6. If the vent line tube connector and pipe are stuck, push and pull to release them.



    A212661
  1. Disconnect the tube clamp, wire harness clamp and connector air inlet line tube.



    A212662
  1. Remove the 3 bolts, clip and charcoal canister assembly.