Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type)

NAVIGATION SYSTEM (for Radio and Display Type) > Data Signal Circuit between Stereo Jack Adapter and Extension Module

for Preparation Click here


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the extension module via this circuit.

WIRING DIAGRAM


E226627E08


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (EXTENSION MODULE - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
  1. Disconnect the extension module connector.

  1. Disconnect the No. 1 stereo jack adapter assembly connector.



    E226480E66
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L124-2 (UDO-) - L151-2 (D-)
    Always
    Below 1 Ω
    L124-3 (UDO+) - L151-3 (D+)
    Always
    Below 1 Ω
    L124-5 (UJSS) - L151-5 (USG1)
    Always
    Below 1 Ω
    L124-2 (UDO-) - Body ground
    Always
    10 kΩ or higher
    L124-3 (UDO+) - Body ground
    Always
    10 kΩ or higher
    L124-5 (UJSS) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Extension Module)
    *b
    Front view of wire harness connector
    (to No. 1 Stereo Jack Adapter Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)