Home › Vehicle Interior › LIGHTING (INT) › PERSONAL LIGHT

PERSONAL LIGHT > INSPECTION

for Preparation Click here



1. INSPECT MAP LIGHT ASSEMBLY (w/o Sliding Roof)


  1. Inspect the interior light operation.



      B162671E39
    1. Connect a positive (+) lead from the battery to terminal 20 (+B1) and a negative (-) lead to terminal 11 (CTY).

    2. Turn the interior light door switch on.

    3. Turn the personal light switch off.

    4. Check that the interior lights come on.

      OK:
      Interior lights come on.

      Text in Illustration 
      *1
      Component without harness connected
      (Map Light Assembly)
      If the result is not as specified, replace the bulb or map light assembly.

  1. Inspect the personal light operation.

    1. Connect a positive (+) lead from the battery to terminal 20 (+B1) and a negative (-) lead to terminal 1 (GND1).

    2. Check that the personal lights come on.

      OK:
      Condition
      Specified Condition
      Personal light switch LH on
      Personal light LH comes on
      Personal light switch LH off
      Personal light LH does not come on
      Personal light switch RH on
      Personal light RH comes on
      Personal light switch RH off
      Personal light RH does not come on

      If the result is not as specified, replace the bulb or map light assembly.



2. INSPECT MAP LIGHT ASSEMBLY (w/ Sliding Roof)


  1. Inspect the interior light operation.



      E191580E01
    1. Connect a positive (+) lead from the battery to terminal 24 (+B1) and a negative (-) lead to terminal 13 (CTY).

    2. Turn the interior light door switch on.

    3. Turn the personal light switch off.

    4. Check that the interior lights come on.

      OK:
      Interior lights come on.

      Text in Illustration 
      *1
      Component without harness connected
      (Map Light Assembly)
      If the result is not as specified, replace the bulb or map light assembly.

  1. Inspect the personal light operation.

    1. Connect a positive (+) lead from the battery to terminal 24 (+B1) and a negative (-) lead to terminal 9 (GND1).

    2. Check that the personal lights come on.

      OK:
      Condition
      Specified Condition
      Personal light switch LH on
      Personal light LH comes on
      Personal light switch LH off
      Personal light LH does not come on
      Personal light switch RH on
      Personal light RH comes on
      Personal light switch RH off
      Personal light RH does not come on

      If the result is not as specified, replace the bulb or map light assembly.