POWER SWITCH > INSTALLATION |
| 1. INSTALL POWER SWITCH |
![]() |
Engage the 2 claws to install the power switch.
| 2. INSTALL UPPER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY |
Connect the connector.
Engage the 3 claws to install the upper instrument panel finish panel sub-assembly.
| 3. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH |
Connect the connector.
Engage the 14 claws to install the instrument cluster finish panel garnish.
| 4. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY |
![]() |
Engage the 7 claws and 2 clips to install the lower center instrument cluster finish panel sub-assembly.
| 5. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY |
![]() |
Connect each connector.
Engage the 6 claws to install the integration control and panel assembly.
| 6. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL |
| 7. INSTALL REAR NO. 3 FLOOR BOARD |
![]() |
Engage the 2 guides to install the rear No. 3 floor board.
| 8. INSTALL REAR DECK FLOOR BOX |
Install the rear deck floor box.
| 9. INSTALL REAR NO. 2 FLOOR BOARD (for Separate Type) |
![]() |
Engage the 3 guides <A>.
Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.