NAVIGATION SYSTEM (for Radio and Display Type) > Navigation Voice Circuit between Radio Receiver and Extension Module |

| 1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - EXTENSION MODULE) |
Disconnect the radio and display receiver assembly connector.
Disconnect the extension module connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| z23-22 (VOL+) - z21-31 (VOL+) | Always | Below 1 Ω |
| z23-23 (VOL-) - z21-30 (VOL-) | Always | Below 1 Ω |
| z23-24 (SHD1) - z21-29 (SHD1) | Always | Below 1 Ω |
| z23-22 (VOL+) - Body ground | Always | 10 kΩ or higher |
| z23-23 (VOL-) - Body ground | Always | 10 kΩ or higher |
| z23-24 (SHD1) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||