AUDIO AND VISUAL SYSTEM (w/o Daytime Running Light) > Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier |

| 1.CHECK HARNESS AND CONNECTOR (NAVIGATION ECU SUB-ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY) |
Disconnect the navigation ECU sub-assembly connector.
Disconnect the stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L143-5 (R+) - L127-1 (FR+) | Always | Below 1 Ω |
| L143-4 (R-) - L127-5 (FR-) | Always | Below 1 Ω |
| L143-3 (L+) - L127-2 (FL+) | Always | Below 1 Ω |
| L143-2 (L-) - L127-6 (FL-) | Always | Below 1 Ω |
| L143-6 (SLD) - Body ground | Always | 10 kΩ or higher |
| L143-5 (R+) - Body ground | Always | 10 kΩ or higher |
| L143-4 (R-) - Body ground | Always | 10 kΩ or higher |
| L143-3 (L+) - Body ground | Always | 10 kΩ or higher |
| L143-2 (L-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||