NAVIGATION SYSTEM (for Radio and Display Type) > Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier |

| 1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY) |
Disconnect the radio and display receiver assembly connector.
Disconnect the stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L143-5 (R+) - L138-8 (R+) | Always | Below 1 Ω |
| L143-4 (R-) - L138-18 (R-) | Always | Below 1 Ω |
| L143-3 (L+) - L138-9 (L+) | Always | Below 1 Ω |
| L143-2 (L-) - L138-19 (L-) | Always | Below 1 Ω |
| L143-6 (SLD) - Body ground | Always | 10 kΩ or higher |
| L143-5 (R+) - Body ground | Always | 10 kΩ or higher |
| L143-4 (R-) - Body ground | Always | 10 kΩ or higher |
| L143-3 (L+) - Body ground | Always | 10 kΩ or higher |
| L143-2 (L-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||