Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (w/o Daytime Running Light)

AUDIO AND VISUAL SYSTEM (w/o Daytime Running Light) > Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter

for Preparation Click here


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the navigation ECU sub-assembly via this circuit.
The sound signal that has been sent is amplified by the stereo component amplifier assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly or speakers.

WIRING DIAGRAM


E229861E21


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION ECU SUB-ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)


    E227392E16
  1. Disconnect the navigation ECU sub-assembly connector.

  1. Disconnect the No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L130-25 (ADPG) - L124-9 (AUXO)
    Always
    Below 1 Ω
    L130-26 (VAR+) - L124-6 (ARO)
    Always
    Below 1 Ω
    L130-28 (VAL+) - L124-7 (ALO)
    Always
    Below 1 Ω
    L130-27 (VA-) - L124-8 (ASGN)
    Always
    Below 1 Ω
    L130-11 (AGND) - L124-10 (AGND)
    Always
    Below 1 Ω
    L130-25 (ADPG) - Body ground
    Always
    10 kΩ or higher
    L130-26 (VAR+) - Body ground
    Always
    10 kΩ or higher
    L130-28 (VAL+) - Body ground
    Always
    10 kΩ or higher
    L130-27 (VA-) - Body ground
    Always
    10 kΩ or higher
    L130-11 (AGND) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Navigation ECU Sub-assembly)
    *b
    Front view of wire harness connector
    (to No. 1 Stereo Jack Adapter Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)