Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM

DTC    P062F-143    Internal Control Module EEPROM Error

DTC    P062F-165    Internal Control Module EEPROM Error

for Preparation Click here


DESCRIPTION

The power management control ECU (HV CPU) monitors its internal operation and it will set this DTC when it detects an internal malfunction. If this DTC is output, replace the power management control ECU (HV CPU).

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P062F
143
ECU internal error
(EEPROM error)
(1 trip detection logic)
Power Management Control ECU
165

MONITOR DESCRIPTION

The power management control ECU (HV CPU) monitors its internal operation. If the internal operation is malfunctioning, the power management control ECU (HV CPU) illuminates the MIL and sets a DTC.

MONITOR STRATEGY


Related DTCs
P062F (INF 143): Internal control module EEPROM
P062F (INF 165): Internal control module EEPROM for battery data
Required sensors / components
Power management control ECU
Frequency of operation
Continuous
Duration
TMC's intellectual property
MIL operation
1 driving cycle/Immediately
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the following DTCs are not present
TMC's intellectual property
Other conditions belong to TMC's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


TMC's intellectual property
-

COMPONENT OPERATING RANGE


Power management control ECU (HV CPU)
DTC P062F (INF 143/165) is not detected

CONFIRMATION DRIVING PATTERN


A218446E20

  1. Connect the Techstream to the DLC3.
  2. Turn the power switch on (IG) and turn the Techstream on.
  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
  4. Turn the power switch off and wait for 30 seconds or more.
  5. Turn the power switch on (IG) and wait for 15 seconds or more, turn the power switch off. [A]
  6. Repeat [A] 3 times. [B]
  7. Turn the power switch on (IG) and turn the Techstream on.
  8. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes. [C]
  9. Read the current DTCs.

    HINT:
    1. If a current DTC is output, the system is malfunctioning.
    2. If a current DTC is not output and want to confirm permanent DTC, perform the following procedure.

  10. Check that permanent DTCs are cleared.
  11. If the permanent DTCs are not cleared, perform the universal trip, and then check for permanent DTCs again.

INSPECTION PROCEDURE

HINT:
  1. There is a possibility that the DTC P062F is issued from the ECUs of the ECM and power management control ECU. Use Techstream to conduct a health check to confirm which ECU the DTC is issued from and then inspect the related system.
  2. After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
    1. Turn the power switch off and wait for 30 seconds or more.
    2. Turn the power switch on (IG) and wait for 15 seconds or more.

1.REPLACE POWER MANAGEMENT CONTROL ECU
  1. Replace the power management control ECU (Click here).


NEXT

COMPLETED