PARKING BRAKE CABLE > INSTALLATION |
| 1. INSTALL NO. 2 PARKING BRAKE CABLE CLAMP |
![]() |
Engage the 2 claws to install a new No. 2 parking brake cable clamp to the No. 3 parking brake cable assembly.
| 2. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY |
Install the No. 3 parking brake cable assembly with the 5 bolts.

![]() |
Install the No. 3 parking brake cable assembly to the rear disc brake cylinder assembly.
| *1 | No. 3 Parking Brake Cable Assembly |
| *2 | Clip |
![]() |
Connect the No. 3 parking brake cable assembly to the rear disc brake cylinder assembly.
![]() |
Engage the clamp to install the No. 2 parking brake cable clamp.
| 3. INSTALL REAR FLOOR SIDE MEMBER COVER LH (w/ Floor Under Cover) |
![]() |
Install the rear floor side member cover LH with the nut and 2 bolts.
| 4. INSTALL FRONT NO. 2 FLOOR HEAT INSULATOR |
![]() |
Install the front No. 2 floor heat insulator with the 3 nuts.
| 5. INSTALL FRONT EXHAUST PIPE ASSEMBLY |
| 6. INSTALL NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY |
![]() |
Connect the No. 3 parking brake cable assembly to the No. 1 parking brake pull rod sub-assembly as shown in the illustration.
Connect the No. 2 parking brake cable assembly to the No. 1 parking brake pull rod sub-assembly.
| 7. INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY |
Pass the No. 1 parking brake cable assembly through the parking brake pedal assembly.
![]() |
Install the clip to the No. 1 parking brake cable assembly.
![]() |
Bend the parking brake pedal claw.
![]() |
Temporarily install the adjusting nut.
| 8. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY |
| 9. INSTALL REAR WHEEL |