Home › Brake › PARKING BRAKE › PARKING BRAKE CABLE

PARKING BRAKE CABLE > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY

HINT:
Refer to the instructions for Removal of the parking brake control pedal assembly (Click here).



3. REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY


    C206659
  1. Remove the adjusting nut.



    C206652
  1. Pull up the parking brake pedal claw.



    C206654
  1. Remove the clip from the No. 1 parking brake cable assembly.

  1. Remove the No. 1 parking brake cable assembly from the parking brake pedal assembly.



4. REMOVE FRONT EXHAUST PIPE ASSEMBLY

HINT:
Refer to the instructions for Removal of the front exhaust pipe assembly (Click here).



5. REMOVE FRONT NO. 2 FLOOR HEAT INSULATOR


    C206656
  1. Remove the 3 nuts and front No. 2 floor heat insulator.



6. REMOVE REAR FLOOR SIDE MEMBER COVER LH (w/ Floor Under Cover)


    C207250
  1. Remove the nut, 2 bolts and rear floor side member cover LH.



7. REMOVE NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY


    C206644
  1. Separate the No. 3 parking brake cable assembly from the No. 1 parking brake pull rod sub-assembly as shown in the illustration.

  1. Separate the No. 2 parking brake cable assembly to remove the No. 1 parking brake pull rod sub-assembly.

    HINT:
    Perform the same procedure as for the No. 3 parking brake cable assembly.



8. REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY


    C206657
  1. Disengage the clamp to separate the No. 2 parking brake cable clamp.



    C155545E01
  1. Separate the No. 3 parking brake cable assembly from the rear disc brake cylinder assembly.



    C155546E04
  1. Disconnect the No. 3 parking brake cable assembly from the rear disc brake cylinder assembly.
    Text in Illustration 
    *1
    No. 3 Parking Brake Cable Assembly
    *2
    Clip
    *3
    Offset Wrench (14 mm)

    HINT:
    Insert an offset wrench (14 mm) at the base of the No. 3 parking brake cable assembly as shown in the illustration to disengage the clip. Pull out the No. 3 parking brake cable assembly from the rear disc brake cylinder assembly.



  1. Remove the 5 bolts and No. 3 parking brake cable assembly.


    C206658



9. REMOVE NO. 2 PARKING BRAKE CABLE CLAMP


  1. for Separate type No. 2 parking brake cable clamp:



      C158971
    1. Disengage the 2 claws to remove the No. 2 parking brake cable clamp from the No. 3 parking brake cable assembly.

  1. for One-piece type No. 2 parking brake cable clamp:

    1. Using pliers or equivalent, disconnect the No. 2 parking brake cable clamp and remove it from the No. 3 parking brake cable assembly.

      HINT:
      No. 2 parking brake cable clamp cannot be reused once removed. Make sure to remove it from the No. 3 parking brake cable clamp.