Home › Vehicle Interior › SEAT › POWER SEAT SWITCH

POWER SEAT SWITCH > INSPECTION

for Preparation Click here



1. INSPECT FRONT POWER SEAT SWITCH LH


    B239569E08
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *1
    Front Vertical Switch
    *2
    Slide Switch
    *3
    Lifter Switch
    *4
    Reclining Switch
    *a
    Component without harness connected
    (Front Power Seat Switch LH)

    Standard Resistance:
    Slide Switch 
    Tester Connection
    Switch Condition
    Specified Condition
    5 - 7
    5 - 8
    Front
    Below 1 Ω
    2 - 11
    2 - 12
    5 - 11
    5 - 12
    Off
    2 - 11
    2 - 12
    5 - 11
    5 - 12
    Rear
    2 - 7
    2 - 8
    Front Vertical Switch 
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 7
    1 - 8
    Up
    Below 1 Ω
    6 - 11
    6 - 12
    1 - 11
    1 - 12
    Off
    6 - 11
    6 - 12
    1 - 11
    1 - 12
    Down
    6 - 7
    6 - 8
    Lifter Switch 
    Tester Connection
    Switch Condition
    Specified Condition
    3 - 7
    3 - 8
    Up
    Below 1 Ω
    4 - 11
    4 - 12
    3 - 11
    3 - 12
    Off
    4 - 11
    4 - 12
    3 - 11
    3 - 12
    Down
    4 - 7
    4 - 8
    Reclining Switch 
    Tester Connection
    Switch Condition
    Specified Condition
    10 - 1
    10 - 6
    10 - 7
    10 - 8
    Front
    Below 1 Ω
    9 - 11
    9 - 12
    10 - 11
    10 - 12
    Off
    9 - 11
    9 - 12
    10 - 11
    10 - 12
    Rear
    9 - 3
    9 - 4
    9 - 7
    9 - 8

    If the result is not as specified, replace the front power seat switch LH.