Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM

AIR CONDITIONING SYSTEM > TERMINALS OF ECU

for Preparation Click here



A/C AMPLIFIER

E124486E36

HINT:
Check from the rear of the connector while it is connected to the A/C amplifier.


Terminal No.
(Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
L17-1 (IG+) - L17-14 (GND)
B - W-B
Power source (IG)
Power switch on (IG)
11 to 14 V
L17-1 (IG+) - L17-14 (GND)
B - W-B
Power source (IG)
Power switch off
Below 1 V
L17-5 (TAM) - L17-13 (SG-2)
BE - G
Ambient temperature sensor signal
Power switch on (IG)
Ambient temperature: 25°C (77°F)
1.35 to 1.75 V
L17-5 (TAM) - L17-13 (SG-2)
BE - G
Ambient temperature sensor signal
Power switch on (IG)
Ambient temperature: 40°C (104°F)
0.9 to 1.2 V
L17-9 (PRE) - L17-13 (SG-2)
L - G
A/C pressure sensor signal
Power switch on (READY)
A/C system operating
Refrigerant pressure: Abnormal pressure (more than 3140 kPa (32.0 kgf/cm2, 455 psi))
4.84 V or higher
L17-9 (PRE) - L17-13 (SG-2)
L - G
A/C pressure sensor signal
Power switch on (READY)
A/C system operating
Refrigerant pressure: Abnormal pressure (less than 196 kPa (2.0 kgf/cm2, 28 psi))
Below 0.73 V
L17-9 (PRE) - L17-13 (SG-2)
L - G
A/C pressure sensor signal
Power switch on (READY)
A/C system operating
Refrigerant pressure: Normal pressure (less than 3140 kPa (32.0 kgf/cm2, 455 psi) and more than 196 kPa (2.0 kgf/cm2, 28 psi))
0.73 to 4.84 V
L17-10 (S5-3) - L17-13 (SG-2)
B - G
Power supply for A/C pressure sensor
Power switch on (IG)
A/C switch on
4.75 to 5.25 V
L17-10 (S5-3) - L17-13 (SG-2)
B - G
Power supply for A/C pressure sensor
Power switch on (IG)
A/C switch off
Below 1 V
L17-11 (CANH)
Y
CAN communication system
-
-
L17-12 (CANL)
BR
CAN communication system
-
-
L17-13 (SG-2) - Body ground
G - Body ground
Ground for A/C pressure sensor, ambient temperature sensor
Always
Below 1 V
L17-14 (GND) - Body ground
W-B - Body ground
Ground for main power supply
Always
Below 1 V
L17-15 (ECOS) - L17-14 (GND)
G - W-B
ECO MODE switch signal
Power switch on (IG)
ECO MODE switch off
11 to 14 V
L17-15 (ECOS) - L17-14 (GND)
G - W-B
ECO MODE switch signal
Power switch on (IG)
ECO MODE switch on
Below 1 V
L17-16 (PTC3) - L17-14 (GND)*1
BR - W-B
PTC heater operation signal
Engine is running (1250 rpm or higher)
Temperature setting: MAX. HOT
Ambient temperature: 10°C (50°F) or lower
Engine coolant temperature: 65°C (149°F) or lower
Light control switch off
Blower switch on
11 to 14 V
L17-18 (PTC1) - L17-14 (GND)*1
W - W-B
PTC heater operation signal
Engine is running (1250 rpm or higher)
Temperature setting: MAX. HOT
Ambient temperature: 10°C (50°F) or lower
Engine coolant temperature: 75°C (167°F) or lower
Light control switch off
Blower switch on
11 to 14 V
L17-21 (B) - L17-14 (GND)
Y - W-B
Power source (Back-up)
Power switch off
11 to 14 V
L17-23 (BLW) - L17-14 (GND)
W - W-B
Blower motor speed control signal
Power switch on (IG)
Blower switch LO
Pulse generation
(See waveform 1)
L17-25 (PVSW) - L17-14 (GND)*2
P - W-B
Solar ventilation switch signal
Solar ventilation switch off
4.5 to 5.5 V
L17-25 (PVSW) - L17-14 (GND)*2
P - W-B
Solar ventilation switch signal
Solar ventilation switch on
Below 1 V
L17-26 (SSLR) - L17-14 (GND)*2
L - W-B
Solar ventilation ECU status signal
Power switch on (IG)
SBI terminal: 7 V or higher
Solar ventilation system: off
Pulse generation
(See waveform 2)
L17-27 (IDH) - L17-14 (GND)*1
L - W-B
Inverter with converter assembly current over signal
Power switch on (IG)
Pulse generation
L17-29 (TR) - L17-34 (SG-1)
B - W
Room temperature sensor signal
Power switch on (IG)
Cabin temperature: 25°C (77°F)
1.8 to 2.2 V
L17-29 (TR) - L17-34 (SG-1)
B - W
Room temperature sensor signal
Power switch on (IG)
Cabin temperature: 40°C (104°F)
1.2 to 1.6 V
L17-33 (TS) - L17-14 (GND)
BR - W-B
Solar sensor signal
Power switch on (IG)
Solar sensor subjected to electric light
0.8 to 4.3 V
L17-33 (TS) - L17-14 (GND)
BR - W-B
Solar sensor signal
Power switch on (IG)
Solar sensor covered with a cloth
Below 0.8 V
L17-34 (SG-1) - Body ground
W - Body ground
Ground for room temperature sensor
Always
Below 1 V
L17-37 (LIN1) - L17-14 (GND)
V - W-B
LIN communication signal
Power switch on (IG)
Pulse generation
L17-38 (PTC2) - L17-14 (GND)*1
B - W-B
PTC heater operation signal
Engine is running (1250 rpm or higher)
Temperature setting: MAX. HOT
Ambient temperature: 10°C (50°F) or lower
Engine coolant temperature: 65°C (149°F) to 70°C (158°F)
Light control switch off
Blower switch on
11 to 14 V
z11-2 (BUS G) - Body ground
-
Ground for BUS IC
Always
Below 1 V
z11-3 (BUS) - z11-2 (BUS G)
-
BUS IC control signal
Power switch on (IG)
Pulse generation
z11-4 (B BUS) - z11-2 (BUS G)
-
Power supply for BUS IC
Power switch off
11 to 14 V
z11-5 (SGA) - Body ground
-
Ground for evaporator temperature sensor
Always
Below 1 V
z11-6 (TEA) - z11-5 (SGA)
-
A/C evaporator temperature sensor signal
Power switch on (IG)
Evaporator temperature: 0°C (32°F)
1.7 to 2.1 V
z11-6 (TEA) - z11-5 (SGA)
-
A/C evaporator temperature sensor signal
Power switch on (IG)
Evaporator temperature: 15°C (59°F)
0.9 to 1.3 V
  1. *1: w/ PTC Heater Assembly
  2. *2: w/ Solar Ventilation System


    E103396E01
  1. Waveform 1:
    Item
    Content
    Terminal No.
    L17-23 (BLW) - L17-14 (GND)
    Tool Setting
    1 V/DIV., 500 μs/DIV.
    Vehicle Condition
    Power switch on (IG)
    Blower switch LO

    HINT:
    The waveform varies with the blower speed.



  2. E193224E04
  3. Waveform 2:
    Item
    Content
    Terminal No.
    L17-26 (SSLR) - L17-14 (GND)
    Tool Setting
    1 V/DIV., 100 ms/DIV.
    Vehicle Condition
    Power switch on (IG)
    SBI terminal: 7 V or higher
    Solar ventilation system: off

    HINT:
    The waveform varies with the communication content.


A/C CONTROL ASSEMBLY

E167392E17

HINT:
Check from the rear of the connector while it is connected to the A/C control assembly.


Terminal No.
(Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
L152-2 (TX+) - L152-8 (GND)
V - W-B
LIN communication signal
Power switch on (IG)
Pulse generation
L152-3 (SWO) - L152-8 (GND)
L - W-B
Steering pad switch assembly signal
No switch pushed
→ R/F switch pushed
→ TEMP+ switch pushed
→ TEMP- switch pushed
4.44 to 5.43 V
→ 1.19 to 1.49 V
→ 2.09 to 2.54 V
→ 3.2 to 3.88 V
L152-5 (IG+) - L152-8 (GND)
B - W-B
Power source (IG)
Power switch off
Below 1 V
L152-5 (IG+) - L152-8 (GND)
B - W-B
Power source (IG)
Power switch on (IG)
11 to 14 V
L152-6 (ILL+) - L152-7 (ILL-)
G - W-B
Light control switch signal
Light control switch off
Below 1 V
L152-6 (ILL+) - L152-7 (ILL-)
G - W-B
Light control switch signal
Light control switch tail or head
11 to 14 V
L152-8 (GND) - Body ground
W-B - Body ground
Ground for front A/C control assembly
Always
Below 1 V