Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RECEIVER

TIRE PRESSURE WARNING RECEIVER > INSTALLATION

for Preparation Click here



1. INSTALL TIRE PRESSURE WARNING RECEIVER


    C206232
  1. Connect the connector.

  1. Engage the 2 tabs into the holes as shown in the illustration to install the tire pressure warning receiver.

  1. Install the bolt.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



2. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH

HINT:
  1. Refer to the procedures from Install Roof Side Inner Garnish Assembly (Click here).
  2. Installation should be performed only for the left side.



3. INSPECT TIRE PRESSURE WARNING SYSTEM
  1. Inspect the tire pressure warning system (Click here).