POWER STEERING SYSTEM (for Brush Type Motor) > DIAGNOSIS SYSTEM |
| CHECK DLC3 |
![]() |
The ECU uses ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format.
| Symbol (Terminal No.) | Terminal Description | Condition | Specified Condition |
| SIL (7) - SG (5) | Bus "+" line | During transmission | Pulse generation |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| SG (5) - Body ground | Signal ground | Always | Below 1 Ω |
| BAT (16) - Body ground | Battery positive | Always | 11 to 14 V |
| CANH (6) - CANL (14) | CAN bus line | Power switch off* | 54 to 69 Ω |
| CANH (6) - CG (4) | HIGH-level CAN bus line | Power switch off* | 200 Ω or higher |
| CANL (14) - CG (4) | LOW-level CAN bus line | Power switch off* | 200 Ω or higher |
| CANH (6) - BAT (16) | HIGH-level CAN bus line | Power switch off* | 6 Ω or higher |
| CANL (14) - BAT (16) | LOW-level CAN bus line | Power switch off* | 6 Ω or higher |
If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.
| CHECK WARNING LIGHT |
![]() |
If a problem occurs in the power steering system, the P/S warning light on the combination meter comes on to inform the driver of the problem.