Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM

WIRELESS DOOR LOCK CONTROL SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the Techstream to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / Main Body / Data List.

  5. Read the Data List according to the display on the Techstream.

    Main Body (Main Body ECU (Multiplex Network Body ECU)) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Wireless Control
    Wireless door lock control function/ON or OFF
    ON: Operating
    OFF: Not operating
    -
    Hazard Answer Back
    Hazard answer-back of wireless/ON or OFF
    ON: Operating
    OFF: Not operating
    -
    Wireless Auto Lock
    Automatic lock function/ON or OFF
    ON: Operating
    OFF: Not operating
    -
    Open Door Warning
    Open door warning/ON or OFF
    ON: Operating
    OFF: Not operating
    -
    Unlock 2 Operation
    2 times operation of wireless unlock/ON or OFF
    ON: All doors unlock when unlock switch pressed twice
    OFF: All doors unlock when unlock switch pressed once
    -
    Panic Function
    Panic function/ON or OFF
    ON: Operating
    OFF: Not operating
    -
    Auto Lock Time
    Automatic lock time/120 s, 60 s or 30 s
    120 s: 120 seconds
    60 s: 60 seconds
    30 s: 30 seconds
    -
    Keyless Entry Buzzer
    Buzzer answer-back of wireless/ON or OFF
    ON: Operating
    OFF: Not operating
    -


ACTIVE TEST

HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing the Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the Techstream to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / Main Body / Active Test.

  5. Perform the Active Test according to the display on the Techstream.

    Main Body (Main Body ECU (Multiplex Network Body ECU)) 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Hazard
    Turn signal flasher relay
    ON/OFF
    Observe headlights and rear combination lights for correct operation
    Illuminated Entry System
    Interior lights and power switch light (Interior light switch is in the door position and all doors are closed)
    ON/OFF
    -
    Wireless Buzzer
    Wireless door lock buzzer
    ON/OFF
    -
    Vehicle Horn
    Vehicle horns
    ON/OFF
    -