COMPRESSOR > INSPECTION |
| 1. INSPECT COMPRESSOR WITH MOTOR ASSEMBLY |
![]() |
Disconnect the compressor with motor assembly connector.
Using a megohmmeter, measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E1-1 (PE) - Body ground | Always | 2 MΩ or higher |
| E1-2 (PB) - Body ground | Always | 2 MΩ or higher |
| *1 | Component without harness connected (Compressor with motor assembly) |