DTC P2511-149 HV CPU Power Relay Sense Circuit Intermittent No Continuity |
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| P2511 | 149 | When the power switch is on (READY), the power management control ECU is reset due to an instantaneous interruption of power source. (1 trip detection logic) |
|
| 1.CHECK BATTERY TERMINAL |
Confirm whether the auxiliary battery terminals have been disconnected recently.
| Result | Proceed to |
| Terminals have been disconnected. | A |
| Terminals have not been disconnected. | B |
|
| ||||
| A | |
| 2.CONFIRM THAT MASTER WARNING LIGHT |
Turn the power switch on (READY) from off.
Confirm that the master warning light illuminates.
| Result | Proceed to |
| Master warning light illuminates. | A |
| Master warning light does not illuminates. | B |
Turn the power switch off.
|
| ||||
| A | |
| 3.CLEAR DTC |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Read and record the DTCs and freeze frame data.
Clear the DTCs and freeze frame data.
Turn the power switch off.
| NEXT | |
| 4.CHECK WHETHER DTC OUTPUT RECURS |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Check if DTCs are output.
| Result | Proceed to |
| P2511-149 is output again. | A |
| DTCs other than P2511-149 are also output. | B |
Turn the power switch off.
|
| ||||
| A | |
| 5.CHECK BATTERY TERMINAL (CONTACT PROBLEM) |
Check the connection of the auxiliary battery terminal.
|
| ||||
| OK | |
| 6.CHECK CONNECTOR CONNECTION CONDITION (POWER MANAGEMENT CONTROL ECU CONNECTOR) |
![]() |
Check the connections of the power management control ECU connectors.
|
| ||||
| OK | |
| 7.CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - IGCT RELAY) |
Remove the IGCT relay from the engine room relay block and junction block assembly.
Disconnect connector A21 and A22 from power management control ECU.

| *1 | Engine Room Relay Block and Junction Block Assembly | *2 | IGCT Relay |
| *a | Rear view of wire harness connector (to Power Management Control ECU) | - | - |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A22-5 (+B1) - 5 (IGCT relay) | Power switch off | Below 1 Ω |
| A21-2 (+B2) - 5 (IGCT relay) | Power switch off | Below 1 Ω |
Install the IGCT relay.
Connect the power management control ECU connector.
|
| ||||
| OK | |
| 8.CHECK FOR INTERMITTENT PROBLEMS |
Check for intermittent problems (Click here).
Check the connection and terminal contact pressure of connectors and wire harnesses between the power management control ECU and the engine room relay block and junction block assembly.
When the power switch is on (READY), jiggle the connectors and wire harnesses between the power management control ECU and the engine room relay block and junction block assembly.
| Result | Proceed to |
| Problem symptom does not recur. | A |
| Problem symptom recurs. | B |
|
| ||||
| A | ||
| ||