CRUISE CONTROL SYSTEM > DATA LIST / ACTIVE TEST |
| DATA LIST |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Powertrain / Cruise Control / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| CCS Vehicle Spd | Vehicle speed / min.: 0 km/h (0 mph), max.: 255 km/h (159 mph) | Actual vehicle speed is displayed | - |
| CCS Mem Vehicle Spd | Vehicle speed / min.: 0 km/h (0 mph), max.: 255 km/h (159 mph) | Actual vehicle speed stored in memory | - |
| Cruise Control | Cruise control / ON or OFF | ON: Cruise control activated OFF: Cruise control deactivated | - |
| Main SW M-CPU | Cruise control switch (M-CPU) / ON or OFF | ON: Cruise main switch on OFF: Cruise main switch off | - |
| CCS Ready M-CPU | Cruise control system standby condition (M-CPU) / ON or OFF | Each time main switch is pushed, ON/OFF changes | - |
| CCS Indicator M-CPU | Cruise main indicator (M-CPU) / ON or OFF | ON: Cruise main indicator light on OFF: Cruise main indicator light off | - |
| Cancel Switch | CANCEL switch / ON or OFF | ON: CANCEL switch on OFF: CANCEL switch off | - |
| SET/COAST Switch | - SET switch / ON or OFF | ON: - SET switch on OFF: - SET switch off | - |
| RES/ACC Switch | + RES switch / ON or OFF | ON: + RES switch on OFF: + RES switch off | - |
| Stop Light SW M-CPU | Stop light switch signal (Main CPU) / ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released | - |
| Cruise Operation Status | Shift position signal (D position) / ON or OFF | ON: Shift lever in D OFF: Shift lever not in D | - |
| Cruise Request Driving Force | Cruise control driving force signal / min.: -51.2 kN, max.: 51.2 kN | Actual driving force | - |
| ACTIVE TEST |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
According to the display on the Techstream, perform the "Active Test".
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Indicat. Lamp Cruise | Cruise main indicator light | ON / OFF | - |
| Indicat. SET | SET indicator light | BLINK / OFF | - |