Vehicle Condition
| Auto Cancel Condition
| Re-operation Condition
|
Cruise main indicator light blinks
| - There is problem with input circuit of stop light switch circuit
- There is problem with cancel circuit
- There is problem with electronically controlled brake system
- There is open or short in stop light switch circuit
- Communication stop between brake booster with master cylinder (skid control ECU) and power management control ECU
- There is problem with hybrid vehicle control system
| - Turn cruise control main switch on again
- Turn power switch off then on (IG) again
|
Cruise main indicator light remains on (Cruise control is canceled)
| - Vehicle speed is lower than low speed limit (approximately. 40 km/h (25 mph)) while running with cruise control on
- Electronically controlled brake system operates
| Push cruise control main switch to + RES
|
- Vehicle speed is lower than stored speed by approximately 16 km/h (10 mph) or more
| Push cruise control main switch to - SET
|