Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type)

NAVIGATION SYSTEM (for Radio and Display Type) > Radio Receiver Power Source Circuit

for Preparation Click here


DESCRIPTION

This is the power source circuit to operate the radio and display receiver assembly.

WIRING DIAGRAM


E236968E18


INSPECTION PROCEDURE

NOTICE:
  1. Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - AUXILIARY BATTERY, BODY GROUND)
  1. Disconnect the radio and display receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below .

    Standard Resistance:
    for 6 Speakers 
    Tester Connection
    Condition
    Specified Condition
    L146-7 (GND1) - Body ground
    Always
    Below 1 Ω
    for 8 Speakers 
    Tester Connection
    Condition
    Specified Condition
    L138-20 (GND1) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    for 6 Speakers 
    Tester Connection
    Condition
    Specified Condition
    L148-4 (+B1) - L146-7 (GND1)
    Power switch off
    11 to 14 V
    L148-3 (ACC1) - L146-7 (GND1)
    Power switch on (ACC)
    11 to 14 V
    L149-1 (IG) - L146-7 (GND1)
    Power switch on (IG)
    11 to 14 V
    for 8 Speakers 
    Tester Connection
    Condition
    Specified Condition
    L138-1 (+B1) - L138-20 (GND1)
    Power switch off
    11 to 14 V
    L138-11 (ACC1) - L138-20 (GND1)
    Power switch on (ACC)
    11 to 14 V
    L149-1 (IG) - L138-20 (GND1)
    Power switch on (IG)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)