Home › Engine / Hybrid System › CRUISE CONTROL › LANE RECOGNITION CAMERA SENSOR

LANE RECOGNITION CAMERA SENSOR > REMOVAL

for Preparation Click here



1. REMOVE INNER REAR VIEW MIRROR COVER


    B229499
  1. Disengage the 2 claws and slide the inner rear view mirror cover as shown in the illustration.



    B229500
  1. Disengage the 6 claws and remove the inner rear view mirror cover.



2. REMOVE ROOF TOP MOULDING


    B232400E01
  1. Disengage the claw <A> as shown in the illustration.

  1. Disengage the 2 claws <B> as shown in the illustration.



    B232399
  1. Disengage the 3 claws and remove the roof top moulding.



3. REMOVE LANE RECOGNITION CAMERA SENSOR ASSEMBLY


E186294
  1. Disconnect the connector.

  1. Remove the 3 bolts.

  1. Detach the clip and remove the lane recognition camera sensor assembly.