Home › Engine / Hybrid System › CRUISE CONTROL › LANE-KEEPING ASSIST SYSTEM

LANE-KEEPING ASSIST SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the Techstream to read the Data List allows values or status of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the Techstream to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the Techstream on.

  4. Using the Techstream, enter the following menus:

    1. Select: All ECUs / (desired menu) / Data List /

  5. Check the values by referring to the table below.

    Radar Cruise 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Country# (F Radar Sens)
    Millimeter wave radar sensor country signal / JPN, NA, EURO, AUS, SAFC, OTHER TWN, CHINA, THAI, GCC, NOFIX
    Actual country code
    -

    Lane Keeping Assist 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Wiper Information
    Wiper operation status / Unoperate, Oil off, Mist, Washer, Unknown, Lo, Hi
    The respective operational status displayed
    -
    LKA Indicator
    LKA indicator light signal / Nothing, Blink, Light
    Light: LKA indicator light turns on
    Nothing: LKA indicator light turns off
    Blink: LKA indicator light blinking
    -
    LKA System Indicator
    Lane-keeping assist system indicator / Unknown, Check, Disable, Adjust
    -
    -
    LKA Main SW
    Lane-keeping assist main switch signal / ON or OFF
    ON: Lane-keeping assist main switch is ON
    OFF: Lane-keeping assist main switch is OFF
    -
    Head Light
    Head light signal / ON or OFF
    Head light signal status
    -
    Head Light (High Beam)
    Head Light (Hi Beam) signal / ON or OFF
    Head Light (Hi Beam) signal status
    -
    Turn Light RH
    Turn Light RH signal / ON or OFF
    Turn Light RH signal status
    -
    Turn Light LH
    Turn Light LH signal / ON or OFF
    Turn Light LH signal status
    -
    Left Lane Type
    Left lane type signal / Dashed or Solid
    Dashed: Left lane dashed
    Solid: Left lane solid
    -
    Right Lane Type
    Right lane type signal / Dashed or Solid
    Dashed: Right lane dashed
    Solid: Right lane solid
    -
    Lane Undetectable
    Lane undetectable signal / Undetectable or Detect
    Undetectable: Lane undetectable
    Detect: Lane detected
    -
    Left Lane Detection
    Left lane detection signal / Undetectable or Detect
    Undetectable: Left lane undetectable
    Detect: Left lane detected
    -
    Right Lane Detection
    Right lane detection signal / Undetectable or Detect
    Undetectable: Right lane undetectable
    Detect: Right lane detected
    -
    Left Lane Change
    Left lane change signal / ON or OFF
    ON: When left lane change is performed
    OFF: When left lane change is not performed
    -
    Right Lane Change
    Right lane change signal / ON or OFF
    ON: When right lane change is performed
    OFF: When right lane change is not performed
    -
    Lane Position
    Lane position / min.: -327.68 m, max.: 327.67 m
    Actual lane position
    -
    Lane Width
    Lane width / min.: 0 m, max.: 655.35 m
    Actual lane width
    -
    Small Steering Force Demand
    Small steering force demand signal / ON or OFF
    ON: Steering assist function operates
    OFF: Steering assist function does not operate
    -
    Lane-Keeping Assist Demand
    Lane-keeping assist demand signal / ON or OFF
    ON: Lane-keeping assist function operates
    OFF: Lane-keeping assist function does not operate
    -
    Skid Control Buzzer Demand
    Skid control buzzer demand signal / ON or OFF
    ON: Skid control buzzer sounds
    OFF: Skid control buzzer does not sound
    -
    Target Steering Wheel Torque
    Target steering wheel torque / min.: -100 N*m, max.: 100 N*m
    Actual steering wheel torque
    -
    Left Lane Indicator
    Left lane recognition signal / Nothing, Heavy, Closing or H blink
    Nothing: Left lane indicator is not shown
    Heavy: Left lane indicator is fully shown
    Closing: Only left lane indicator outline is shown
    H blink: Left lane indicator is blinking
    -
    Right Lane Indicator
    Right lane recognition signal / Nothing, Heavy, Closing or H blink
    Nothing: Right lane indicator is not shown
    Heavy: Right lane indicator is fully shown
    Closing: Only right lane indicator outline is shown
    H blink: Right lane indicator is blinking
    -
    Steering Indicator
    Meter display signal of lane-keeping assist function / Nothing, Light or Blink
    Nothing: Steering wheel assistance is not displayed
    Light: Steering wheel assistance is displayed
    Blink: Steering wheel assistance is blinking
    -
    LKA Abnormal Buzzer
    Lane-keeping assist system abnormal buzzer signal / ON or OFF
    ON: Lane-keeping assist system abnormal
    OFF: Lane-keeping assist system normal
    -
    Lane Detection Impossible Buz
    Lane-keeping detection impossible buzzer signal / Nothing, Light or Blink
    Light: Lane-keeping detection impossible buzzer sounds
    Nothing: Lane-keeping detection impossible buzzer does not sound
    Blink: Ready indicator turns blink
    -
    Ready Indicator
    Ready indicator light signal / Nothing, Light or Blink
    Nothing: Ready indicator turns on
    Blink: Ready indicator turns off
    Light: Ready indicator turns blinking
    -
    LKA Temporarily Disable
    Lane-keeping assist system temporarily disabled signal / ON or OFF
    ON: Lane-keeping assist system is temporarily disabled
    OFF: Lane-keeping assist system is operating
    -
    EPS Trq Sens Output
    EPS torque sensor output signal / -7 N/m to 7 N/m
    The torque sensor output signal status displayed
    -
    The Number of DTCs
    Number of DTCs / min.: 0, max.: 255
    Actual number of DTCs
    -

    ABS/VSC/TRAC 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Vehicle Speed
    Vehicle speed/ min.: 0 km/h (0 mph), max.: 326.4 km/h (204 mph)
    Actual vehicle speed is displayed
    -


ACTIVE TEST

HINT:
Using the Techstream to perform Active Test allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Test early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Test.

  1. Connect the Techstream to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the Techstream on.

  4. Using the Techstream, enter the following menus:

    1. Select: All ECUs / (desired menu) / Active Test /

  5. Perform the Active Test by referring to the table below.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Drift From The Lane
    LKA indicator light ON / OFF
    ON / OFF
    -

    ABS/VSC/TRAC 
    Tester Display
    Test Part
    Control Range
    Diagnosis Note
    Buzzer
    Skid control buzzer sounds
    ON / OFF
    -