Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Navigation Receiver Type)

NAVIGATION SYSTEM (for Navigation Receiver Type) > Satellite Radio Broadcast cannot be Selected or After Selecting Broadcast, Broadcast cannot be Added into Memory

for Preparation Click here


INSPECTION PROCEDURE

NOTICE:
  1. Some satellite radio broadcasts require payment. A contract must be made between a satellite radio company and the user. If the contract expires, it will not be possible to listen to the broadcast.
  2. After replacing the navigation ECU sub-assembly of vehicles subscribed to pay-type satellite radio broadcasts, registration of the XM radio ID is necessary.

1.CHECK SATELLITE RADIO
  1. Check radio condition.

    Result:
    Result
    Proceed to
    Broadcast cannot be selected
    A
    Broadcast can be selected, but selection cannot be memorized
    B



B
Go to step 2
A

REPLACE NAVIGATION ECU SUB-ASSEMBLY (Click here)  

2.CHECK SATELLITE RADIO
  1. Check the number of preset channels.

    OK:
    36 channels have already been preset.



NG
Go to step 3
OK

END (ONLY 36 CHANNELS CAN BE PRESET) 

3.CHECK AUXILIARY BATTERY
  1. Check if the auxiliary battery was replaced.

    OK:
    Auxiliary battery was not replaced.



NG
Go to step 4
OK

REPLACE NAVIGATION ECU SUB-ASSEMBLY (Click here)  

4.ADD PRESET CHANNEL INTO MEMORY AGAIN
  1. Check if the preset channels that have been cleared can be added into memory again.

    OK:
    Preset channels can be added into memory.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END