FRONT BRAKE FLEXIBLE HOSE > REMOVAL |
| 1. REMOVE REAR NO. 2 FLOOR BOARD (for Separate Type) |
![]() |
Disengage the 2 guides <A> as shown in the illustration.
Disengage the 3 guides <B> and remove the rear No. 2 floor board.
| 2. REMOVE REAR DECK FLOOR BOX |
Remove the rear deck floor box.
| 3. REMOVE REAR NO. 3 FLOOR BOARD |
![]() |
Disengage the 2 guides and remove the rear No. 3 floor board.
| 4. DISABLE BRAKE CONTROL |
Wait at least 2 minutes after the power switch off.
![]() |
Disconnect the reservoir level switch connector with the parking brake applied.
Disconnect the cable from the auxiliary battery negative (-) terminal.
Depress the brake pedal 40 times or more to return all the fluid in the accumulator back to the reservoir.
Check that the brake pedal can not be further depressed.
Release the parking brake.
| 5. REMOVE FRONT WHEEL |
| 6. DRAIN BRAKE FLUID |
| 7. REMOVE FRONT FLEXIBLE HOSE |
![]() |
Remove the union bolt and gasket, and separate the front flexible hose from the disc brake cylinder assembly.
![]() |
Using a union nut wrench, disconnect the brake line while holding the front flexible hose with a wrench.
| *1 | Clip |
Remove the clip.
![]() |
Remove the bolt (A) and separate the front speed sensor bracket from the absorber bracket.
| *1 | Front Speed Sensor Bracket |
| *2 | Front Flexible Hose Bracket |
Remove the bolt (B) and front flexible hose from the steering knuckle.