Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY

STEERING COLUMN ASSEMBLY > INSPECTION

for Preparation Click here


NOTICE:
When using a vise, do not overtighten it.



1. INSPECT PRELOAD


    C206268E01
  1. Secure the steering column assembly in a vise.

  1. Using SST, turn the main shaft and measure the preload.

    SST
    09616-00011  

    Torque:
    Preload (for Brush Type Motor):
    1.1 N*m{ 11 kgf*cm , 10 in.*lbf } or less
    Preload (for Brushless Type Motor):
    0.9 to 1.5 N*m{ 10 to 15 kgf*cm , 8 to 12 in.*lbf }

    If the preload is not as specified, replace the power steering motor assembly or electric power steering column sub-assembly with a new one.



2. INSPECT STEERING COLUMN ASSEMBLY


  1. Inspect the bushings.



      C209250E01
    1. Check that the 2 bushings are securely installed to the steering column assembly.
      Text in Illustration 
      *1
      Bushing
      If the 2 bushings are installed improperly, replace the electric power steering column sub-assembly with a new one.

    2. Check the 2 bushings for deformation and damage.
      If the bushings are deformed or damaged, replace the electric power steering column sub-assembly with a new one.



  1. Inspect the capsules.



      C232485E01
    1. Check that the 2 capsules are securely installed to the steering column assembly as shown in the illustration.

      Standard Dimension:
      A
      B
      2 mm (0.0787 in.)
      17 mm (0.669 in.)

      Text in Illustration 
      *1
      Capsule
      If the capsules are not positioned as specified, replace the electric power steering column sub-assembly with a new one.

    2. Check the 2 capsules for deformation and damage.
      If either of the capsules is deformed, loose, missing or damaged, replace the electric power steering column sub-assembly with a new one.