Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL

BRAKE PEDAL > REMOVAL

for Preparation Click here



1. REMOVE UPPER INSTRUMENT PANEL ASSEMBLY
(Click here)


2. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B223658
  1. Remove the 2 screws <D>.

  1. Disengage the claw and guide.

  1. Disconnect each connector and remove the No. 1 instrument panel under cover sub-assembly.



3. REMOVE STOP LIGHT SWITCH ASSEMBLY


    E235384
  1. Disconnect the connector.



    E235385
  1. Turn the stop light switch assembly counterclockwise and remove it.



4. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER


5. REMOVE BRAKE PEDAL RETURN SPRING


    C205687
  1. Remove the brake pedal return spring from the brake pedal support assembly and push rod pin.



6. REMOVE PUSH ROD PIN


    C205688
  1. Remove the clip and push rod pin to separate the brake pedal support assembly from the push rod clevis.



7. SEPARATE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


    C205686
  1. Remove the bolt and nut, and separate the instrument panel junction block assembly.



8. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY


    C205684
  1. Remove the bolt and separate the brake pedal support assembly from the instrument panel reinforcement.



    C247849
  1. Disengage the clamp and disconnect the connector from the brake pedal stroke sensor assembly.



    C205689
  1. Remove the 4 nuts and brake pedal support assembly.



    C209159
  1. Remove the nut from the brake pedal support assembly.