Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL

BRAKE PEDAL > REASSEMBLY

for Preparation Click here



1. INSTALL BRAKE PEDAL PAD


2. INSTALL BRAKE PEDAL STROKE SENSOR ASSEMBLY

NOTICE:
  1. Do not drop the brake pedal stroke sensor assembly.
  2. If the brake pedal stroke sensor assembly has been dropped, replace the brake pedal stroke sensor assembly with a new one.
  3. When installing a new brake pedal stroke sensor assembly, do not break the brake pedal stroke sensor assembly lever set pin before tightening the 2 nuts.



    C247844E01
  1. Temporarily install the brake pedal stroke sensor assembly with the 2 nuts.
    Text in Illustration 
    *1
    Brake Pedal Groove
    *2
    Brake Pedal Stroke Sensor Assembly Lever

    NOTICE:
    1. Engage the brake pedal stroke sensor assembly lever with the brake pedal groove.
    2. Check that there is no foreign matter attached to the contact surface of the brake pedal stroke sensor assembly.
    3. Check that the tip of the brake pedal stroke sensor assembly lever is protruding from the brake pedal groove.

    HINT:
    Fully tighten the 2 nuts after the brake pedal support assembly is installed.