Home › Power Source / Network › NETWORKING › LIN COMMUNICATION SYSTEM

DTC    B2789    No Response from ID BOX

for Preparation Click here


DESCRIPTION

This DTC is stored when LIN communication between the certification ECU (smart key ECU assembly) and ID code box (immobiliser code ECU) stops for 10 seconds or more.

DTC No.
DTC Detection Condition
Trouble Area
B2789
No communication between certification ECU (smart key ECU assembly) and ID code box (immobiliser code ECU) for 10 seconds or more.
  1. ID code box (immobiliser code ECU)
  2. Certification ECU (smart key ECU assembly)
  3. Wire harness or connector
  4. ECU-B2 fuse

WIRING DIAGRAM


B203744E74


INSPECTION PROCEDURE

NOTICE:
  1. Inspect the fuses for circuits related to this system before performing the following inspection procedure.
  2. If the certification ECU (smart key ECU assembly) is replaced, register the key.
  3. If the ID code box (immobiliser code ECU) is replaced, register the ECU code and ECU communication ID.
  4. When using the Techstream to troubleshoot with the power switch off:
    Connect the Techstream to the DLC3, and turn the courtesy switch on and off at 1.5-second intervals until communication between the Techstream and vehicle begins.

1.CHECK HARNESS AND CONNECTOR (ID CODE BOX - BATTERY AND BODY GROUND)


    B176985E02
  1. Disconnect the L10 ID code box connector.

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L10-8 (GND) - Body ground
    Always
    Below 1 Ω

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    L10-1 (+B) - Body ground
    Power switch off
    11 to 14 V

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to ID Code Box (Immobiliser Code ECU))



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ID CODE BOX)


    B218382E02
  1. Disconnect the L62 certification ECU (smart key ECU assembly) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L62-29 (LIN) - L10-3 (LIN1)
    Always
    Below 1 Ω
    L62-29 (LIN) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Certification ECU (Smart Key ECU Assembly))
    *2
    Front view of wire harness connector
    (to ID Code Box (Immobiliser Code ECU))



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE ID CODE BOX (IMMOBILISER CODE ECU)
  1. Replace the ID code box (immobiliser code ECU) (Click here).


NEXT


4.CHECK DTC OUTPUT
  1. Clear the DTC (Click here).

  1. Recheck for DTCs.

    OK:
    DTC B2789 is not output.



NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (Click here)
OK

END (ID CODE BOX (IMMOBILISER CODE ECU) WAS DEFECTIVE)