BACK DOOR OPENER SWITCH > INSTALLATION |
| 1. INSTALL BACK DOOR OPENER SWITCH ASSEMBLY |
![]() |
Install the back door opener switch assembly.
| 2. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY |
![]() |
Wind double-sided tape around a string as shown in the illustration.
| *1 | String |
| *2 | Double-sided Tape |
| *3 | Center line |
| a | 1600.0 mm (62.992 in.) |
| b | 50.0 to 75.0 mm (1.969 to 2.953 in.) |
| c | 30.0 mm (1.181 in.) |
![]() |
Lift the ends of the No. 2 back window molding lower, and attach each end to the back door glass with tape.
| *1 | String |
| *2 | Double-sided Tape |
| *3 | No. 2 back window lower moulding |
| *4 | Tape |
| a | 40.0 mm (1.575 in.) |
Make a loop in the center of the string, and attach it to the back of the No. 2 back window lower moulding with the double-sided tape on the string.
Attach the loop and ends of the string to the back door glass with tape as shown in the illustration.
Install the 4 new gaskets to the back door outside garnish sub-assembly.
Install 11 new clips (back door outside garnish clip) to the back door outside garnish sub-assembly.
![]() |
Engage the 11 clips to install the back door outside garnish sub-assembly.
![]() |
Install the 4 nuts.
Apply soapy water to the No. 2 back window molding lower.
![]() |
Remove the string by slowly pulling out toward each end from the center toward the sides of the vehicle as shown in the illustration.
Check that the No. 2 back window molding lower is not pinched between the back door and the back door outside garnish sub-assembly.
Remove the tape.
| 3. INSTALL BACK DOOR TRIM BOARD ASSEMBLY |
![]() |
Engage the 11 clips and 2 claws to install the back door panel trim assembly.