Home › Vehicle Exterior › WIPER / WASHER › REAR WIPER MOTOR

REAR WIPER MOTOR > INSTALLATION

for Preparation Click here



1. INSTALL REAR WIPER MOTOR ASSEMBLY


    E190059
  1. Install the rear wiper motor assembly with the 3 bolts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the connector.



2. INSTALL BACK DOOR TRIM BOARD


    B227903
  1. Engage the 5 clips and 2 guides to install the back door trim board.



3. INSTALL BACK DOOR TRIM BOARD ASSEMBLY


    B227902
  1. Engage the 11 clips and 2 claws to install the back door panel trim assembly.



4. INSTALL BACK DOOR SIDE GARNISH LH


    B227898
  1. Engage the 3 clips and 2 claws to install the back door side garnish LH.



5. INSTALL BACK DOOR SIDE GARNISH RH


    B227897
  1. Engage the 3 clips and 2 claws to install the back door side garnish RH.



6. INSTALL UPPER BACK DOOR TRIM PANEL ASSEMBLY


    B227896
  1. Engage the 4 clips and 4 claws to install the upper back door trim panel assembly.



7. INSTALL REAR WIPER MOTOR GROMMET


    E167875E05
  1. Apply MP grease to the entire surface of the rear wiper motor grommet lip.
    Text in Illustration 
    *1
    MP grease

    HINT:
    Make sure that the hole does not get clogged with grease and the grooves on the lip are filled with grease.



    E189299E01
  1. Install the rear wiper motor grommet.

    HINT:
    Install the grommet with its alignment mark facing up.
    Text in Illustration 
    *1
    Alignment Mark



8. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY
  1. Operate the wiper and stop the windshield wiper motor at the automatic stop position.



  1. When reusing the rear wiper arm and blade assembly:



      E168919E03
    1. Clean the wiper arm serrations.
      Text in Illustration 
      *1
      Wiper Arm Serration



  1. When reusing the rear wiper motor assembly:



      E164908E03
    1. Clean the wiper pivot serrations with a wire brush.
      Text in Illustration 
      *1
      Wire Brush
      *2
      Wiper Pivot Serration



    E190076E01
  1. Install the rear wiper arm and blade assembly with the nut to the position shown in the illustration.
    Text in Illustration 
    *1
    Ceramic Dot

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

    HINT:
    Hold the wiper arm by hand while tightening the nut.

  1. Operate the rear wiper while spraying washer fluid onto the back door glass. Make sure that the rear wiper functions properly and the wiper does not come into contact with the vehicle body.



9. INSTALL REAR WIPER ARM HEAD CAP


    E189297
  1. Engage the 2 claws to install the rear wiper arm head cap.



    E190057
  1. Engage the 2 claws to close the rear wiper arm head cap as shown in the illustration.