Home › Vehicle Exterior › WIPER / WASHER › REAR WIPER MOTOR

REAR WIPER MOTOR > INSPECTION

for Preparation Click here



1. INSPECT REAR WIPER MOTOR ASSEMBLY


    E169055E01
  1. Check the wiper intermittent operation.

    1. Connect a battery positive (+) lead to terminal 4 (+B), and a negative (-) lead to terminal 2 (C1) and terminal 5 (E), and check that the motor operates.

      OK:
      Motor operates.

      Text in Illustration 
      *1
      Component without harness connected
      (Rear Wiper Motor and Bracket Assembly)
      If the result is not as specified, replace the motor assembly.



    E169055E02
  1. Check the wiper continuous operation.

    1. Connect a battery positive (+) lead to terminal 4 (+B), and a negative (-) lead to terminal 3 (LS) and terminal 5 (E), and check that the motor operates.

      OK:
      Motor operates.

      Text in Illustration 
      *1
      Component without harness connected
      (Rear Wiper Motor and Bracket Assembly)
      If the result is not as specified, replace the motor assembly.