Home › Vehicle Exterior › WIPER / WASHER › REAR WIPER MOTOR

REAR WIPER MOTOR > REMOVAL

for Preparation Click here



1. REMOVE UPPER BACK DOOR TRIM PANEL ASSEMBLY


    B227895
  1. Using a moulding remover, disengage the 4 clips and 4 claws, and remove the upper back door trim panel assembly.



2. REMOVE BACK DOOR SIDE GARNISH RH


    B227897
  1. Disengage the 3 clips and 2 claws, and remove the back door side garnish RH.



3. REMOVE BACK DOOR SIDE GARNISH LH


    B227898
  1. Disengage the 3 clips and 2 claws, and remove the back door side garnish LH.



4. REMOVE BACK DOOR TRIM BOARD ASSEMBLY


    B227899
  1. Using a moulding remover, disengage the clip and claw.



    B227900
  1. Using a moulding remover, disengage the clip and claw.



    B257325E01
  1. Disengage the 3 clips in the order shown in the illustration.



    B257326
  1. Disengage the 2 clips by pulling the back door trim board assembly in the direction indicated by the arrows in the illustration.



    B257327E01
  1. Remove the back door trim board assembly by pulling it in the direction indicated by the arrow in the illustration to disengage the 4 clips.
    Text in Illustration 
    *1
    Back Door Trim Board Assembly
    *2
    Back Door Panel
    *a
    The portion that may be damaged due to interference

    NOTICE:
    Make sure to pull the back door trim board assembly in the direction indicated by the arrow in the illustration. If the back door trim board assembly is removed from the lower part, the door pull handle mounting area may interfere with the back door panel, resulting in damage to the back door trim board assembly.



5. REMOVE BACK DOOR TRIM BOARD


    B227903
  1. Disengage the 5 clips and 2 guides, and remove the back door trim board.



6. REMOVE REAR WIPER ARM HEAD CAP


    E189296
  1. Disengage the 2 claws and open the rear wiper arm head cap as shown in the illustration.



    E189297
  1. Disengage the 2 claws and remove the rear wiper arm head cap.



7. REMOVE REAR WIPER ARM AND BLADE ASSEMBLY


    E189298
  1. Remove the nut, and the rear wiper arm and blade assembly.



8. REMOVE REAR WIPER MOTOR GROMMET


    E189299
  1. Remove the rear wiper motor grommet.



9. REMOVE REAR WIPER MOTOR ASSEMBLY


    E189295
  1. Disconnect the connector.

  1. Remove the 3 bolts and the rear wiper motor assembly.