Home › Vehicle Exterior › DOOR / HATCH › HOOD

HOOD > DISASSEMBLY

for Preparation Click here



1. REMOVE HOOD AUXILIARY CATCH HOOK ASSEMBLY


    B227876
  1. Remove the 2 bolts and hood auxiliary catch hook assembly.



2. REMOVE HOOD INSULATOR


    B227877
  1. Using a clip remover, remove the 6 clips and hood insulator.



3. REMOVE WASHER NOZZLE SUB-ASSEMBLY


    E189323E01
  1. Using a screwdriver, disengage the 2 claws and separate the washer nozzle sub-assembly as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

    NOTICE:
    1. Be careful not to damage the windshield.
    2. Washer nozzles cannot be reused.

    HINT:
    Tape the screwdriver tip before use.



    E189326
  1. Remove the washer nozzle sub-assembly from the washer hose.



4. DISCONNECT WASHER HOSE ASSEMBLY


    B227878
  1. Using a clip remover, disengage the 6 clips and disconnect the washer hose assembly.



5. REMOVE HOOD STAY HOLDER


    B227879
  1. Disengage the 2 claws and remove the hood stay holder.



6. REMOVE HOOD SUPPORT ROD


    B227880
  1. Disengage the 3 claws and remove the hood support rod.



7. REMOVE HOOD STAY BRACKET


    B227881
  1. Remove the bolt and hood stay bracket.