Home › Engine / Hybrid System › 2ZR-FXE LUBRICATION › OIL PRESSURE SWITCH

OIL PRESSURE SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY


    A085603E08
  1. Apply adhesive to 2 or 3 threads of the oil pressure switch.
    Text in Illustration 
    *1
    Adhesive

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent



    A153125
  1. Using a 24 mm deep socket wrench, install the oil pressure switch.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine for at least 1 hour after installation.

  1. Connect the oil pressure switch connector.



2. INSPECT FOR ENGINE OIL LEAK
  1. Put the engine in inspection mode (Click here).

  1. Warm up the engine. Make sure that there are no engine oil leaks from the area that was worked on.



3. INSTALL FRONT WHEEL RH

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }