IGNITION COIL AND SPARK PLUG > INSTALLATION |
| 1. INSTALL SPARK PLUG |
![]() |
Using a 14 mm spark plug wrench, install the 4 spark plugs.
| 2. INSTALL IGNITION COIL ASSEMBLY |
![]() |
Install the 4 ignition coils with the 4 bolts.
Connect the 4 ignition coil assembly connectors.
| 3. INSTALL NO. 2 CYLINDER HEAD COVER |
![]() |
Engage the 3 clips to install the cover.
| 4. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY |
![]() |
Install the outer cowl top panel sub-assembly with the 9 bolts.
![]() |
Bend the water guard plate RH and engage the claw.
![]() |
Bend the No. 1 heater air duct splash shield seal and engage the claw.
![]() |
Engage the 2 clamps and guide to install the wire harness.
| *1 | Clamp |
| *2 | Guide |
| 5. INSTALL COWL BODY MOUNTING REINFORCEMENT LH |
![]() |
Install the cowl body mounting reinforcement LH with the 3 bolts.
| 6. INSTALL WINDSHIELD WIPER MOTOR AND LINK |
Install the windshield wiper motor and link (Click here).
| 7. PERFORM INITIALIZATION |
Perform "Inspection After Repair" after replacing a spark plug or ignition coil assembly (Click here).