IGNITION COIL AND SPARK PLUG > REMOVAL |
| 1. REMOVE WINDSHIELD WIPER MOTOR AND LINK |
Remove the windshield wiper motor and link (Click here).
| 2. REMOVE COWL BODY MOUNTING REINFORCEMENT LH |
![]() |
Remove the 3 bolts and cowl body mounting reinforcement LH.
| 3. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY |
![]() |
Disengage the 2 clamps and guide of the wire harness.
| *1 | Clamp |
| *2 | Guide |
![]() |
Disengage the claw and bend the No. 1 heater air duct splash shield seal.
![]() |
Disengage the claw and bend the water guard plate RH.
![]() |
Remove the 9 bolts and outer cowl top panel sub-assembly.
| 4. REMOVE NO. 2 CYLINDER HEAD COVER |
![]() |
Remove the 3 clips and No. 2 cylinder head cover.
| 5. REMOVE IGNITION COIL ASSEMBLY |
![]() |
Disconnect the 4 ignition coil connectors.
Remove the 4 bolts and 4 ignition coils.
| 6. REMOVE SPARK PLUG |
![]() |
Using a 14 mm spark plug wrench, remove the 4 spark plugs.