Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › AIR FUEL RATIO SENSOR

AIR FUEL RATIO SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL AIR FUEL RATIO SENSOR

HINT:
Perform "Inspection After Repair" after replacing the air fuel ratio sensor (Click here).



    A216698
  1. Using SST, install the air fuel ratio sensor.

    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    NOTICE:
    1. The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
    2. The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) (Click here).
    3. This torque value is effective when SST is parallel to the torque wrench.



    A212298
  1. Connect the air fuel ratio sensor connector and clamp.



2. INSTALL NO. 2 CYLINDER HEAD COVER


    A213020
  1. Engage the 3 clips to install the cover.

    NOTICE:
    1. Be sure to engage the clips securely.
    2. Do not apply excessive force or hit the cover to engage the clips. This may cause the cover to break.



3. INSPECT FOR EXHAUST GAS LEAK


4. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY


    C205669
  1. Install the outer cowl top panel sub-assembly with the 9 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }



    C205673
  1. Bend the water guard plate RH and engage the claw.



    C205671
  1. Bend the No. 1 heater air duct splash shield seal and engage the claw.



    C205668E01
  1. Engage the 2 clamps and guide to install the wire harness.
    Text in Illustration 
    *1
    Clamp
    *2
    Guide



5. INSTALL COWL BODY MOUNTING REINFORCEMENT LH


    C205667
  1. Install the cowl body mounting reinforcement LH with the 3 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }



6. INSTALL WINDSHIELD WIPER MOTOR AND LINK
  1. Install the windshield wiper motor and link (Click here).



7. PERFORM INITIALIZATION
  1. Perform "Inspection After Repair" after replacing the air fuel ratio sensor (Click here).