Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › AIR FUEL RATIO SENSOR

AIR FUEL RATIO SENSOR > REMOVAL

for Preparation Click here



1. REMOVE WINDSHIELD WIPER MOTOR AND LINK
  1. Remove the windshield wiper motor and link (Click here).



2. REMOVE COWL BODY MOUNTING REINFORCEMENT LH


    C205667
  1. Remove the 3 bolts and cowl body mounting reinforcement LH.



3. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY


    C205668E01
  1. Disengage the 2 clamps and guide of the wire harness.
    Text in Illustration 
    *1
    Clamp
    *2
    Guide



    C205670
  1. Disengage the claw and bend the No. 1 heater air duct splash shield seal.



    C205672
  1. Disengage the claw and bend the water guard plate RH.



    C205669
  1. Remove the 9 bolts and outer cowl top panel sub-assembly.



4. REMOVE NO. 2 CYLINDER HEAD COVER


    A213020
  1. Remove the 3 clips and No. 2 cylinder head cover.

    NOTICE:
    1. Attempting to disengage both front and rear clips at the same time may cause the cover to break.
    2. Pull the cover straight up to remove. Attempting to pull the cover forward may cause it to break.



5. REMOVE AIR FUEL RATIO SENSOR


    A212298
  1. Disconnect the air fuel ratio sensor connector and clamp.



    A216699
  1. Using SST, remove the air fuel ratio sensor.

    SST
    09224-00010