Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL HEATED OXYGEN SENSOR

HINT:
Perform "Inspection After Repair" after replacing the heated oxygen sensor (Click here).



    A212296E01
  1. Using SST, install the heated oxygen sensor onto the front exhaust pipe.
    Text in Illustration 
    *1
    Fulcrum Length
    *2
    30 mm

    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    NOTICE:
    1. This torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.81 in.) and SST with a length of 30 mm (1.18 in.) (Click here).
    2. This torque value is effective when SST is parallel to the torque wrench.



    A212297
  1. Install the wire harness clamp bracket and connect the wire harness clamp.



    A212294
  1. Pass the sensor connector through the floor panel and install the grommet.

  1. Connect the heated oxygen sensor connector.



2. INSPECT FOR EXHAUST GAS LEAK


3. INSTALL NO. 2 ENGINE UNDER COVER


    A212293
  1. Install the No. 2 engine under cover with the 4 clips.



4. PERFORM INITIALIZATION
  1. Perform "Inspection After Repair" after replacing the heated oxygen sensor (Click here).