Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 2 ENGINE UNDER COVER


    A212293
  1. Remove the 4 clips and No. 2 engine under cover.



2. REMOVE HEATED OXYGEN SENSOR


    A212294
  1. Disconnect the heated oxygen sensor connector.

  1. Remove the grommet and pull the sensor connector out of the cabin through the floor panel.



    A212297
  1. Remove the wire harness clamp bracket and disconnect the wire harness clamp.



    A212295
  1. Using SST, remove the heated oxygen sensor.

    SST
    09224-00010