Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CRANK POSITION SENSOR


    A159394
  1. Apply a light coat of engine oil to the O-ring on the crank position sensor.



    A216697
    A212299
  1. Install the crank position sensor with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    Connect the crank position sensor connector.



2. INSPECT FOR OIL LEAK


3. INSTALL NO. 1 ENGINE UNDER COVER


4. INSTALL REAR ENGINE UNDER COVER RH