Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › THROTTLE BODY

THROTTLE BODY > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER


2. DRAIN ENGINE COOLANT (for Engine)

NOTICE:
Do not remove the reservoir tank cap and radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



  1. Loosen the radiator drain cock plug and drain the coolant.


    A251110E01


    Text in Illustration 
    *1
    Reservoir Tank Cap
    *2
    Radiator Drain Cock Plug

    HINT:
    Collect the coolant in a container and dispose of it according to the local regulations.



3. REMOVE NO. 2 CYLINDER HEAD COVER


    A213020
  1. Remove the 3 clips and No. 2 cylinder head cover.

    NOTICE:
    1. Attempting to disengage both front and rear clips at the same time may cause the cover to break.
    2. Pull the cover straight up to remove. Attempting to pull the cover forward may cause it to break.



4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A212311
  1. Disconnect the connector.



    A288960
  1. Loosen the hose clamp and disconnect the air cleaner hose assembly.

  1. Remove the 2 clamps and air cleaner cap subassembly.



5. REMOVE INLET AIR CLEANER ASSEMBLY


    A269507
  1. Remove the 2 bolts and inlet air cleaner assembly.



6. REMOVE AIR CLEANER CASE
  1. Remove the air cleaner filter element sub-assembly.



    A212314
  1. Separate the hose from the 3 clamps.

  1. Remove the 3 bolts and air cleaner case.



7. REMOVE AIR CLEANER HOSE ASSEMBLY


    A212315
  1. Disconnect the ventilation hose from the cylinder head cover sub-assembly.

  1. Loosen the hose clamp and remove the air cleaner hose assembly.



8. REMOVE THROTTLE BODY ASSEMBLY


  1. Type A:



      A212316
    1. Disconnect the throttle body connector and the 2 water by-pass hoses.

    2. Remove the 2 bolts, 2 nuts and throttle body assembly.



    3. A212317
    4. Remove the gasket from the intake manifold.



  1. Type B:



      A288947
    1. Disconnect the connector.

    2. Disconnect the No. 1 water by-pass hose and No. 2 water bypass hose.

    3. Remove the 4 bolts and throttle body assembly.



    4. A288948
    5. Remove the gasket from the intake manifold.