Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › KNOCK SENSOR

KNOCK SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL KNOCK SENSOR

HINT:
Perform "Inspection After Repair" after replacing the knock sensor (Click here).



    A158260E07
  1. Install the knock sensor with the bolt as shown in the illustration.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

    NOTICE:
    Make sure that the knock sensor is in the correct position.

  1. Connect the knock sensor connector.



2. INSTALL INTAKE MANIFOLD
  1. Install the intake manifold (Click here).



3. PERFORM INITIALIZATION
  1. Perform "Inspection After Repair" after replacing the knock sensor (Click here).