DTC P0AC0-817 Hybrid Battery Pack Current Sensor Circuit Range / Performance |

| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| P0AC0 | 817 | Abnormal battery current sensor characteristics An abnormality in the battery current sensor characteristics is detected based on the relationship between hybrid system power consumption and battery power output. (1 trip detection logic) |
|
| DTC No. | Data List |
| P0AC0-817 | Power Resource IB |
| Related DTCs | P0AC0 (INF 817): Current sensor malfunction (gain or offset) |
| Required sensors / components | Battery current sensor |
| Frequency of operation | Continuous |
| Duration | TMC's intellectual property |
| MIL operation | 1 driving cycle |
| Sequence of operation | None |
| The monitor will run whenever the following DTCs are not present | TMC's intellectual property |
| Other conditions belong to TMC's intellectual property | - |
| TMC's intellectual property | - |
| Power management control ECU (HV CPU) | DTC P0AC0 (INF 817) is not detected |
| 1.CHECK DTC OUTPUT (HV) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Check if DTCs are output.
| Result | Proceed to |
| P0AC0-817 only is output. | A |
| P0AFC-123 is output. | B |
Turn the power switch off.
|
| ||||
| A | |
| 2.REPLACE HYBRID BATTERY JUNCTION BLOCK |
Replace the hybrid battery junction block(Click here).
| NEXT | |
| 3.CLEAR DTC |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Read and record the DTCs and freeze frame data.
Clear DTCs and freeze frame data.
Turn the power switch off.
| NEXT | |
| 4.PERFORM ROAD TEST |
Perform a "Confirmation Driving Pattern".
| NEXT | |
| 5.CHECK DTC OUTPUT (HV) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Check if DTCs are output.
| Result | Proceed to |
| P0AC0-817 is not output. | A |
| P0AC0-817 is output again. | B |
Turn the power switch off.
|
| ||||
| A | ||
| ||