Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR (for Rear Side)

WASHER MOTOR (for Rear Side) > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL RH


2. REMOVE FRONT FENDER LINER RH


    E187035E01
  1. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.



    E187036
  1. Remove the 10 clips and 4 screws.

  1. Using a clip remover, remove the grommet and the front fender liner RH.

    HINT:
    The grommet needs to be replaced with new one because it will break when it is removed.



3. DRAIN WASHER FLUID


    E187041
  1. Disconnect the washer hose from the rear washer motor and pump assembly, and drain the washer fluid.

    HINT:
    Use a container to collect the washer fluid.



4. REMOVE REAR WASHER MOTOR AND PUMP ASSEMBLY


    E190070
  1. Disconnect the connector.

  1. Remove the rear washer motor and pump assembly.